NUT Shutdown Timing and low-batt

[phillxnet (Philip Guyton)]

@littleyo Welcome to the Rockstor community forum.

Re:

@littleyo

But tests show that it doesn’t matter. “low-batt” shuts down the server.
how can I disable this?

You should be able to apply, by-hand, any additional NUT configuration that you require via the command line. And to see how configure NUT via our Web-UI take a look at our wiki doc entry for this:

Network UPS Tools (NUT) - Rockstor's implementation

This is a wikified post documenting how NUT is implimented in Rockstor and is intended to serve as a live document on the same; user documentation is available at UPS / NUT Setup . Please update this developer document when you make any changes to the NUT instantiation within Rockstor’s code. Also any suggestions on how this might be done better are very welcome; but please make sure that these suggestions are clearly indicated as such; this helps to maintain the relationship between this docume…

Customizations you may need to what the Web-UI has instantiated will be re-written if you end-up re-configuring via the Web-UI but as long as you take account of this, and at least start out with a Rockstor Web-UI NUT config - you should be able to modify it to acommodate your flaky UPS communications: assuming NUT has this capability (it likely does as it is very flexible).

So in short take a look at the above docs to see how we start out with our config. And then take a look at upstream’s NUT-UPS’s configuration options: https://networkupstools.org/ to see if/how it might accommodate your requirements.

Hope that helps.